Assembly Instructions
Contents
1x BEACH BAG
1x COTTON BIB
4x WOODEN SLATS
3x WOODEN BARS
6x ELASTIC BANDS
2x STRAPS
6x SCREWS
2x SCREW SLEEVES + SCREWS
4x WASHERS
2x BELT SLIDERS
Tools
The only tool you need is either a ...
We recommend using a power drill and assembling on a table with a non-slip surface.
assemble frame
- Screw wooden bar tightly to top ends of the two long wooden slats with velcro strips pointing towards bottom end.*
- Pull cotton bib (logo facing down) over second long wooden bar. Screw bar tightly to bottom ends of both wooden slats.
* Top end of wooden slat marked by red dot on inward facing drill hole.
assemble kickstand
- Screw remaining bar tightly to bottom ends of the two short wooden slats.**
** Bottom end of short slat marked by red dot on inward facing drill hole.
attach kickstand
- Push screw sleeves inwards through center drill holes of frame.
- Slide on two washers per sleeve (see detailed illustration).
- Slide on kickstand and screw tightly with small sleeve screws.*
Tighten all screws on frame one last time so wooden bars sit tight.
* Tighten small screws regularly, as they can loosen over time.
attach elastic straps
- Press on velcro strip (A), wrap around slat once (B) and extend to opposite side (C).
Fasten other end on opposite side the same way.
attach straps
- Press on velcro strip as shown (A), wrap around bar twice and weave downwards through elastic bands (B).
- Pull strap through cutout (C), then through belt slider (D).
- Wrap around rear bar and fasten by pulling through belt slider once more (E).
Assembly Instructions
Contents
1x BEACH BAG
1x COTTON BIB
4x WOODEN SLATS
3x WOODEN BARS
6x ELASTIC BANDS
2x STRAPS
6x SCREWS
2x SCREW SLEEVES + SCREWS
4x WASHERS
2x BELT SLIDERS
Tools
The only tool you need is either a ...
We recommend using a power drill and assembling on a table with a non-slip surface.
assemble frame
- Screw wooden bar tightly to top ends of the two long wooden slats with velcro strips pointing towards bottom end.*
- Pull cotton bib (logo facing down) over second long wooden bar. Screw bar tightly to bottom ends of both wooden slats.
* Top end of wooden slat marked by red dot on inward facing drill hole.
assemble kickstand
- Screw remaining bar tightly to bottom ends of the two short wooden slats.**
** Bottom end of short slat marked by red dot on inward facing drill hole.
attach kickstand
- Push screw sleeves inwards through center drill holes of frame.
- Slide on two washers per sleeve (see detailed illustration).
- Slide on kickstand and screw tightly with small sleeve screws.*
Tighten all screws on frame one last time so wooden bars sit tight.
* Tighten small screws regularly, as they can loosen over time.
attach elastic straps
- Press on velcro strip (A), wrap around slat once (B) and extend to opposite side (C).
Fasten other end on opposite side the same way.
attach straps
- Press on velcro strip as shown (A), wrap around bar twice and weave downwards through elastic bands (B).
- Pull strap through cutout (C), then through belt slider (D).
- Wrap around rear bar and fasten by pulling through belt slider once more (E).